8 Rotors Professional UAV Drone Stringing Power Line for Transmission Line Construction Industrial Grade

Quick details:

Flight Controller: DJI V2 + GPS;

Max flight speed: 14m/s;

Relative flying height: Max 2000m

Charge: Dual battery charger

Specification:

Instruction:

When installing the propeller, the propeller is on the bottom and the gasket is on the top. Tighte the two screws to complete the installation.
Note: The two heads of the propeller are red and correspond to the head section. The left side is No. 1 pulp and the right side is No. 2 pulp. Install No. 1, No. 2, No. 1, No. 2...
Tip: The propeller can cause injury, please be careful!
In any case, if you need to debug the aircraft, please remove the propeller!

Note:

Heading off①: In this gear, the drone is flying according to the instructions of the remote controller operator to operate the left and right joysticks. (In this gear, pay attention to the head orientation and the navigation channel, forward to the nose and backward to the tail. forward)

Heading lock②: The heading direction when starting the locking is the reference system. When setting the heading lock, you first need to determine the direction in which you stand. When you set it, no matter where the drone is, where the head is facing, push and pull the right stick back and forth, the drone will move along the trajectory parallel to your front and rear direction. .

Return point lock③: Pulling the right lever backwards will return the drone to the takeoff point, no matter where the nose is facing.

Return mode④: In this mode, the drone returns and gradually enters the field of view. At about 20 meters from the return point, the unmanned person automatically raises/lowers 20m from the ground and begins to descend. In order to avoid deviations, the remote control can be operated to manually drop the drone in the visible range.

ATT mode⑤: In this mode, the GPS module is not used for positioning, and the drone only provides posture stabilization. In actual operation, the unmanned person apparently drifts and cannot hover. The flying hand is required to continuously correct the position of the drone through the remote controller.

GPS Mode⑥: UAVs use GPS modules or multi-directional vision systems to achieve precise hovering, pointing flight, planning routes, etc. all need to be performed in this mode.

Workshop:

Founded in 2006, NEWLANDLE is a high-tech enterprise specializing in the R&D, manufacture, sales and service of industrial-grade UAV systems. We manufacture and supply all kind of Agriculture drone, Industrial drone and Camera drone, we establish R&D and production workshop in different countries, we are committed to becoming the leading brand of industrial-grade drones in the world.